DELL 9.8(0.0) User Manual
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
S4820T
Syntax
neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
receive | both] path-count
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
decimal format.
peer-group-
name
name
(OPTIONAL) Enter the name of the peer group.
send
Enter the keyword send to indicate that the system sends
multiple paths to peers.
multiple paths to peers.
receive
Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
accepts multiple paths from peers.
both
Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
and accepts multiple paths from peers.
path-count
Enter the number paths supported. The range is from 2 to
64.
64.
Defaults
none
Command
Modes
Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.8.0
Introduced on the S4810.
Related
Commands
Commands
prefix without the new paths implicitly replacing any previous ones.
446
Border Gateway Protocol