DELL 9.8(0.0) User Manual
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
Parameters
percentage
(Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
range is from 1 to 100% in units of 1%.
Defaults
none
Command
Modes
Modes
QOS-POLICY-OUT-ETS
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Information
By default, equal bandwidth is assigned to each port queue and each dot1p priority
in a priority group. To configure bandwidth amounts in associated dot1p queues,
use the bandwidth-percentage command. When specified bandwidth is
assigned to some port queues and not to others, the remaining bandwidth (100%
minus assigned bandwidth amount) is equally distributed to unassigned non-strict
priority queues in the priority group. The sum of the allocated bandwidth to all
queues in a priority group must be 100% of the bandwidth on the link.
in a priority group. To configure bandwidth amounts in associated dot1p queues,
use the bandwidth-percentage command. When specified bandwidth is
assigned to some port queues and not to others, the remaining bandwidth (100%
minus assigned bandwidth amount) is equally distributed to unassigned non-strict
priority queues in the priority group. The sum of the allocated bandwidth to all
queues in a priority group must be 100% of the bandwidth on the link.
ETS-assigned bandwidth allocation applies only to data queues, not to control
queues.
queues.
The configuration of bandwidth allocation and strict-queue scheduling is not
supported at the same time for a priority group. If you configure both, the
configured bandwidth allocation is ignored for priority-group traffic when you
apply the output policy on an interface.
supported at the same time for a priority group. If you configure both, the
configured bandwidth allocation is ignored for priority-group traffic when you
apply the output policy on an interface.
By default, equal bandwidth is assigned to each priority group in the ETS output
policy applied to an egress port if you did not configure bandwidth allocation. The
policy applied to an egress port if you did not configure bandwidth allocation. The
570
Data Center Bridging (DCB)