DELL 9.8(0.0) User Manual
Parameters
milliseconds
Enter the number of milliseconds as the interval. For IGMP
version 2, the range is from 100 to 25599. For IGMP version
3, the range is from 100 to 65535. The default value is 1000
milliseconds.
version 2, the range is from 100 to 25599. For IGMP version
3, the range is from 100 to 65535. The default value is 1000
milliseconds.
Defaults
1000 milliseconds
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
For IGMP version 2, the Interval range is from 100 to 25599.
Introduced on the S6000-ON.
Introduced on the S6000-ON.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
E-Series legacy
command
command
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
S4820T
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds
Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
range is from 1 to 18000. The default is 60 seconds.
Defaults
60 seconds
Internet Group Management Protocol (IGMP)
767