DELL 9.8(0.0) User Manual
Parameters
half
Enter the keyword half to set the physical interface to
transmit only in one direction.
transmit only in one direction.
full
Enter the keyword full to set the physical interface to
transmit in both directions.
transmit in both directions.
Defaults
Not configured.
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.4.1.0
Introduced
Usage
Information
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 Mbps or 100 Mbps, you can also execute the duplex
command.
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 Mbps or 100 Mbps, you can also execute the duplex
command.
Related
Commands
Commands
— enables or disables auto-negotiation on an interface.
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on} [negotiate]
Interfaces
795