DELL 9.8(0.0) User Manual
management route
Configure a static route that points to the Management interface or a forwarding router.
S4820T
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet} command.
length}} {forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet} command.
Parameters
ip-address
mask
mask
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
format) of the destination subnet.
ipv6-address
prefix-length
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
fields of zeros.
forwarding-
router-address
router-address
Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
address (x:x:x:x::x format) of a forwarding router.
managementet
hernet
hernet
Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Management interface on the Primary RPM.
fortyGigE
Enter the keyword fortyGigE to specify a forty Gigbit
Ethernet interface.
Ethernet interface.
vlan
Enter the keyword vlan to specify a vlan interface.
tengigabitether
net
net
Enter the keyword tengigabitethernet to specify a ten Gigabit
Ethernete interface.
Ethernete interface.
Defaults
Not configured.
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
936
IPv4 Routing