DELL 9.8(0.0) User Manual
Parameters
limit
Maximum number of IPv6 routes allowed in a VRF. Valid
range is from 1 to 8000 (or maximum allowable for that
platform if smaller value).
range is from 1 to 8000 (or maximum allowable for that
platform if smaller value).
warning-
threshold
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of IPv6 routes reaches the
specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional routes will not be
allowed into the RTM ( route table manager ) itself.
limit value. When the number of IPv6 routes reaches the
specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional routes will not be
allowed into the RTM ( route table manager ) itself.
warning-only
When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic IPv6 routes
reaches the limit. Additional dynamic IPv6 routes will still be
allowed.
be thrown when maximum number of dynamic IPv6 routes
reaches the limit. Additional dynamic IPv6 routes will still be
allowed.
Defaults
No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command
Modes
Modes
CONFIGURATION-VRF
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OSCommand Line Reference Guide.
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, and Z9500.
ON, and Z9500.
Usage
Information
Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to
8000), then it has unlimited space that extends to the maximum number of entries
allowed for the system. This command is not applicable to the default and
management VRFs.
8000), then it has unlimited space that extends to the maximum number of entries
allowed for the system. This command is not applicable to the default and
management VRFs.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
S4820T
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the
no ipv6 address autoconfig command.
To disable the address autoconfig operation on the management interface, use the
no ipv6 address autoconfig command.
988
IPv6 Basics