DELL 9.8(0.0) User Manual
4
Control and Monitoring
This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP).
protocol (FTP), and trivial file transfer protocol (TFTP).
NOTE: This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
Parameters
unit-id
Enter the stack member unit identifier of the stack member
to reset. The S4820T range is from 0 to 11.
to reset. The S4820T range is from 0 to 11.
NOTE: The S4820T commands accept Unit ID numbers
from 0 to 11, though S4820T supports stacking of up to
six units.
from 0 to 11, though S4820T supports stacking of up to
six units.
queue size
Enter the queue size of the stack member. The range is from
0 to 15.
0 to 15.
Defaults
Not configured
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
Control and Monitoring
99