DELL 9.8(0.0) User Manual
ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
S4820T
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps
Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the
rate-limiting.
second. The range is from 1 to 200, where 0 disables the
rate-limiting.
Default
100 pps
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
S4820T
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the protocol operations to fill
the field, use the no ipv6 flowlabel-zero command.
To disable the 0 from being set in the field and allow the protocol operations to fill
the field, use the no ipv6 flowlabel-zero command.
Default
Disabled
992
IPv6 Basics