Raritan Computer 4.7 User Manual
Chapter 7: Operation - Administrator Functions
127
To control power from the Outlet Selection Menu
A connected Power Strip is treated as a tiered device. The Power Strip,
therefore, has its own device menu consisting of “ports” for each power
outlet with which power can be controlled on a per-outlet basis.
therefore, has its own device menu consisting of “ports” for each power
outlet with which power can be controlled on a per-outlet basis.
Navigate the Paragon II OSUI Selection Menu, select the Raritan
Power Strip and press Enter. You will now be at the “Outlet
Selection” menu.
Power Strip and press Enter. You will now be at the “Outlet
Selection” menu.
A list of outlets (up to 8 per page) will appear. Outlets in green are
switched ON; outlets in black are switched OFF.
switched ON; outlets in black are switched OFF.
Press X, O, or R to turn off, turn on, or recycle power to the outlet
respectively. Type yes to confirm turning off the power if you select
X or R.
respectively. Type yes to confirm turning off the power if you select
X or R.
Getting Power Strip Unit Status from the Outlet Selection Menu
At any time while navigating the “Outlet Selection” Menu, pressing F11
will provide a status screen showing certain parameters of the connected
power strip. These parameters vary depending on the model of the
power strip, and they may include:
will provide a status screen showing certain parameters of the connected
power strip. These parameters vary depending on the model of the
power strip, and they may include:
Average power
True RMS Current
True RMS Voltage
Internal Temperature
Apparent Power
Maximum Detected
Outlet Circuit Breaker
Note: Unlike second-tier channel ports, the power outlet “channel ports”
will not appear in the list of channels when the OSUI is sorted by the
channel name.
will not appear in the list of channels when the OSUI is sorted by the
channel name.
Paragon II Network Port
Paragon II has a network port and is designed as a network-aware
device. This network port is used to communicate with Paragon Manager
administrative software, which can be downloaded from
device. This network port is used to communicate with Paragon Manager
administrative software, which can be downloaded from
Raritan website
(
). See Paragon Manager User Guide for
additional information. This user guide is available on Raritan website's
Firmware and Documentation section
(
).
Note: The Ethernet port on the Paragon switch is hard coded (not
configurable) and supports only 10-BaseT/half duplex.
configurable) and supports only 10-BaseT/half duplex.