Q-Logic 59022-11 A 4-13 User Manual
A – Command Line Interface
Set Command
Set Command
A-58
59022-11 A
0
Set Command
Sets a variety of switch parameters.
Authority
Admin session for all keywords except Alarm, Beacon, and Pagebreak which are
available without an Admin session.
available without an Admin session.
Syntax
set
alarm [option]
beacon [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
timezone
beacon [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
timezone
Keywords
alarm [option]
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
clear
Clears the alarm log history. This value requires an Admin session.
on
Enables the display of alarms in the session output stream.
off
Disables the display of alarms in the session output stream.
Clears the alarm log history. This value requires an Admin session.
on
Enables the display of alarms in the session output stream.
off
Disables the display of alarms in the session output stream.
beacon [state]
Enables or disables the flashing of the Logged-In LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
Enables or disables the flashing of the Logged-In LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
on
Enables the flashing beacon.
off
Disables the flashing beacon.
Enables the flashing beacon.
off
Disables the flashing beacon.
config [option]
Sets switch, port, port threshold alarm, security, and zoning configuration
parameters. Refer to the
Sets switch, port, port threshold alarm, security, and zoning configuration
parameters. Refer to the
.
log [option]
Specifies the type of entries to be entered in the event log. Refer to the
Specifies the type of entries to be entered in the event log. Refer to the
.