Nortech Systems RS-422/485 User Manual

3. Select option 2.

Then, press ENTER to continue.

4. Select either option 5 or option 6:

or

Then, press ENTER to continue.

5. The program will step you through the process of adding a new statement to 

assign the appropriate I/O signals to a block, and then to a byte (1 to 4) within a 
block. With the sDIO, the first 8 input channels are mapped to byte 1, the second 8 
input channels to byte 2, and so on. See 

. Using 

this process, you must assign groups of signal numbers to bytes 1 to 4 for each 
block. See the 

 for the input settings of a system 

with two sDIO modules. When you are done editing the I/O choose not to add a 
new statement.

6. Save the changes, if you are satisfied with your choices.

7. Continue to select 0 to return through the higher menus. Select 0 once more to exit 

to the system monitor.

8. Disconnect your AdeptWindowsPC or serial communication session to the 

SmartController.

9. Cycle the 24VDC input power to the sDIO.

10. Cycle the 24VDC input power to the SmartController.

11. Reconnect your AdeptWindowsPC or serial communication session to the 

SmartController.