Nortech Systems RS-422/485 User Manual

When CMD1 is pressed, the system attempts to load the file 

CMD1.V2 from the default disk, and COMMAND the program CMD1.   The program file 
CMD1.V2 must reside on the default disk, and it must contain a command program 
named “cmd1”. If the file does not exist, or does not contain a correctly named program, 
the operation will be aborted and the appropriate error message will be displayed on the 
LCD. If CMD2 is pressed, the file CMD2.V2 will be loaded and “cmd2” will be 
COMMANDed. 

Using the Prog Set button, you may select a new program to execute, set the starting step 
number, set how many cycles of the program to perform, set the monitor speed, and start 
a memory-resident application program. See 

.

Press the NEW soft button and the LCD displays: 

 SELECT A NEW PROGRAM

prog1

prog2

prog3

prog4

<MORE>

To select a different program, press the soft button under the program name. To see 
additional programs (if there are more programs), press the <MORE> soft button.

Press STEP and the step number will blink, and the typing cursor will appear next 

to the step number. Use the data entry buttons to enter the program step to start 
execution. Complete the entry by pressing REC/DONE. 

Press CYCLE and the cycle count will blink, and the typing cursor will appear 

next to the cycle count. Use the data entry keys to enter the number of program cycles to 
execute. Complete the entry by pressing REC/DONE. 

Press SPEED and the current monitor speed will blink, and the typing cursor 

will appear next to the monitor speed. Use the data entry keys to enter a new monitor 
speed. Complete the entry by pressing REC/DONE. 

The Start button works only when High Power is enabled (this option cannot be 

used with DRY.RUN enabled). Press START and the program displayed above the NEW 
soft button will begin execution. 

EDIT

DISP

CLR

ERR

PROG

SET

CMD

 NEW

    1
STEP

     1
CYCLE

   50
SPEED

START