Nortech Systems RS-422/485 User Manual
Adept SmartController User’s Guide, Rev. E
37
SmartController Operation
3
3.1
SmartController CS Connectors and Indicators
Figure 3-1. SmartController CS
All the connectors on the SmartController use standard density spacing, D-subminiature
connectors. For customization purposes, the user needs to provide connectors of the
appropriate gender and pin count or use optional Adept cables.
connectors. For customization purposes, the user needs to provide connectors of the
appropriate gender and pin count or use optional Adept cables.
NOTE: The SmartController CX has all of the connectors and indicators
described in this section for the SmartController CS, plus additional ones
covered in
described in this section for the SmartController CS, plus additional ones
covered in
.
1. Top Three Status LEDs
The top three two-color LEDs indicate diagnostic test, power control, and communication
status.
status.
During system bootup, the red OK/SF and HPE/ES LEDs are lit and the red LAN/HD LED
blinks. After system bootup, the OK/SF LED should show green. If the HPE/ES LED shows
red, the E-Stop circuit is open. During CompactFlash reads and writes, the LAN/HD LED
pulses red. When the controller is active on an Ethernet network, the LAN/HD LED pulses
green.
blinks. After system bootup, the OK/SF LED should show green. If the HPE/ES LED shows
red, the E-Stop circuit is open. During CompactFlash reads and writes, the LAN/HD LED
pulses red. When the controller is active on an Ethernet network, the LAN/HD LED pulses
green.
Table 3-1. SmartController LEDs
LED
Green Indicates
Red Indicates
OK/SF
System OK
System Fault
HPE/ES
High Power Enabled
E-Stop Open
LAN/HD
Ethernet Access
Read/Write from
CompactFlash
CompactFlash
1 2 3
RS-422/485
XUSR
XSYS
SF
XMCP
1.1
SmartController CS
LAN
HPE
OFF
24V
5A
ON
RS-232/TERM
XFP
HD
ES
XDIO
Eth 10/100
*S/N 1000-XXXXX*
SW1
Device Net
SmartServo
XDC1 XDC2
- +
- +
1 2 3 4
OK
R
1.2