Nortech Systems RS-232/TERM User Manual
Appendix A - sDIO Module
96
Adept SmartController User’s Guide, Rev. E
Table Mounting the sDIO
To table mount the sDIO, install two brackets on each side near the bottom of the unit. Use
the screws from the accessories kit; see
the screws from the accessories kit; see
Figure A-4. Table Mounting the sDIO
Stack Mounting
See the
for information on stack mounting
the sDIO and SmartController.
A.2
Installing the sDIO
The following procedure details the steps required to successfully install the sDIO.
To install the sDIO module:
1. Remove the sDIO module from its box and set it up near the robot or mount it as
described in
2. Ensure that the 24VDC input power to the SmartController is disengaged.
3. Connect a 24VDC cable from the XDC2 port on the SmartController to the XDC1
port on the sDIO. Continue to daisy-chain the input power from each sDIO to the
next. See
next. See
for cabling requirements.
NOTE: European installations must be in accordance with the EN60204
standard.
standard.
R 3.6
16.3
391.9
16.0
378.7
24.9
24.1
120.8
21.7
4X 40356-00001
12.1
29.5
120.9
4X M3 x 6MM
BOTH SIDES
BOTH SIDES