National Instruments NI CVS-1450 Series User Manual
Chapter 4
Digital I/O Functionality
© National Instruments Corporation
4-15
Figure 4-8. Example Connections
When connecting to TTL inputs on the CVS-1450 device, match the output
impedance of the transmitting device to the characteristic impedance of the
cable. For example, if the cable characteristic impedance is 118
impedance of the transmitting device to the characteristic impedance of the
cable. For example, if the cable characteristic impedance is 118
Ω, make
R
s
equal to 118
Ω, as shown in Figure 4-8.
Typical System Setup
Digital I/O configuration varies depending on the number of cameras your
system setup requires. You can access the digital I/O through the 44-pin
DSUB connector or through the three SMB connectors.
system setup requires. You can access the digital I/O through the 44-pin
DSUB connector or through the three SMB connectors.
The digital I/O capabilities of the SMB connectors on the CVS-1450 device
are ideal for typical single-camera applications. The SMB connectors are
labeled TRIG 0, TRIG 1, and TRIG 2.
are ideal for typical single-camera applications. The SMB connectors are
labeled TRIG 0, TRIG 1, and TRIG 2.
TTL OUT(0)
Receiving
Equipment
TTL IN(0)
118
Ω
44-Pin
DSUB
3
2
2
16
17
17
62 k
Ω
Transmitting
Equipment
R
S
TRIG 1
75
Ω
TRIG 1
SMB
RG-179
Coaxial Cable
+5 V
CVS-1450 device
Receiving
Equipment