Fujitsu eLux NG S26361-F2600-L134 User Manual

 

 

 

 

 

 

Build # 27

  

88

 

 

eLux NG supports the Connect2Air™ WLAN E-5400 D1700 USB adapter from Fujitsu 
Siemens Computers. The Connect2Air USB adapter supports data transfer rates of up to 54 
Mb/s and 64 and 128 bit WEP encryption. This product is not supported by all hardware 
platforms.  
 
Enabling wireless LAN on your device involves the following: 
1.  Installing the required firmware 
2.  Attaching the USB network adapter 
3.  Configuring network hardware settings and entering the WEP key for encrypted transfer 
 

To use wireless LAN you must install the following firmware: 

1.  Start ELIAS NG and add the following packages to the device’s IDF:  

•  WLAN USB D1700 (wireless) This FPM is found in the base OS package. 

Note: If you cannot activate this FPM, remove the “Cisco Aironet Utility” (airo) EPM 
from the IDF first. 

2.  Save the IDF and exit ELIAS NG. 
3.  Install the software on the Thin Client by performing a firmware update over Ethernet. 

 

Insert the USB network adapter into your device according to the directions that came with the 
adapter. 
 

Figure 59: Setup > Hardware > Wireless LAN 

1.  In eLux NG, from the Setup tab, click the Hardware subtab.  
2. Choose 

 from the Network type list.  

3.  (optional) Enter the WEP key you received from your network administrator. If you 

leave this field blank, the connection will be unencrypted. 

4.  Wired Equivalent Privacy (WEP) is based on the IEEE 802.11b standard and provides 

data confidentiality.  

5.  (optional) Enter the SSID information you got from your network administrator.