3com 8807 User Manual

C

HAPTER

 3: I

NSTALLATION

 P

REPARATION

The Switch 8800 Family adopts redundant PSUs for AC PSU:

Rated voltage: 100 VAC to 240 VAC, 50 Hz or 60 Hz

Maximum tolerance: 90 VAC to 264 VAC, 50 Hz or 60 Hz

Maximum power output: 1200 W (Switch 8807)/2000 W (Switch 8810/Switch 
8814) 

For the sake of adequate ventilation and easy equipment maintenance, you are 
recommended to keep one meter of clearance between the rear/front of the 
switch cabinet and the wall surface or other devices. If the optional cabinet is 
desired, the clear height of the equipment room must be more than 3 meters 
inclusive.

Before cabinet-mounting the switch, make sure that the cabinet meets the 
following requirements:

■

Better mount the switch in an open cabinet. However, if you want to mount it 
in a closed cabinet, make sure of the availability of a good ventilation system.

■

Make sure that the cabinet stands steadily enough to support the weight of the 
switch and the accessories.

■

Make sure that the switch fits the cabinet size. Leave some clearance beside 
the left and right panels of the switch for chassis ventilation.

n 

Table 70   Required installation tools

 

Long tape, ruler (1 meter in length), marking pen, powder 
marker, pencil 

One percussion drill, several drill bits, one vacuum cleaner 

Flat-module screwdriver P4 -- 75 mm

Phillips screwdriver P1 -- 100mm, P2 -- 150mm and P3 -- 
250mm

Socket wrench M5

Box-end wrench M6

Double ring spanner (10-12) or open-end wrench (10-12) 

Sharp-nose pliers, diagonal pliers, vices, hand-held electric 
drill, file, handsaw, crowbar, rubber hammer 

Brush, tweezers, paper knife, hand bellows, electric iron, 
solder wire, fork, ladder 

ESD-preventive wrist strap, cable stripper, crimping pliers, 
RJ-45 crimping pliers, wire punchdown tool 

Multimeter, 500V Meg-ohmmeter (used for measuring the 
insulation resistance), error detector, optical power meter, 
earth resistance tester