3com LANplex 2500 User Manual
The LANplex system will automatically reset when a module has been
installed with the power on.
installed with the power on.
If you physically change the configuration of the system after defining an IP
interface, the port designated for that interface may no longer be valid. You
may have to redefine the interface. For information on defining an IP
interface, see the Administration Console User Guide for your LANplex
system.
interface, the port designated for that interface may no longer be valid. You
may have to redefine the interface. For information on defining an IP
interface, see the Administration Console User Guide for your LANplex
system.
Option Module
Diagnostics
Module diagnostics run at power up or when replacing a module with the
power on. During diagnostics, the module’s port status
power on. During diagnostics, the module’s port status
Error
LED is lit
yellow. When diagnostics are successfully completed, the port status
Active
LED turns green. If the port status
Error
LED remains yellow, the port is not
operational. If the module’s
Board Error
LED is lit yellow, the module has
failed a diagnostic test. To troubleshoot module failures, see Chapter 7:
Troubleshooting the System
in your
Getting Started
guide
.
100BASE-FX
option module
option module
Green = Active
Yellow = Error
Yellow = Error
Board
Error
Error
Port Status
Active
Error
1
2
3
4
5
6
7
8
Power
Run
Processor
Power
Fan
Temp
Config
Inserted
ERROR
PCMCIA
LANplex 2500
Green = Active
Yellow = Error
Yellow = Error
Board
Error
Error
Port Status
Active
Error
Captive screw
Port Status
Active
Error
Green = Active
Yellow = Error
Yellow = Error
Board Error
Inserted
1
2
Board
Error
Port Status
Active
Error
100 Base FX
Male SC
connector
connector
R
3Com Corporation
5400 Bayfront Plaza
Santa Clara, California
95052-8154
5400 Bayfront Plaza
Santa Clara, California
95052-8154
© 3Com Corporation, 1996. All rights reserved. No part of this documentation may be reproduced in any form
or by any means or used to make any derivative work (such as translation, transformation, or adaptation)
without permission from 3Com Corporation.
or by any means or used to make any derivative work (such as translation, transformation, or adaptation)
without permission from 3Com Corporation.
3Com Corporation reserves the right to revise this documentation and to make changes in content from time
to time without obligation on the part of 3Com Corporation to provide notification of such revision or change.
to time without obligation on the part of 3Com Corporation to provide notification of such revision or change.
3Com Corporation provides this documentation without warranty of any kind, either implied or expressed,
including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
3Com may make improvements or changes in the product(s) and/or the program(s) described in this
documentation at any time.
including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
3Com may make improvements or changes in the product(s) and/or the program(s) described in this
documentation at any time.
3Com and LANplex are registered trademarks of 3Com Corporation. 3Com registered trademarks are registered
in the United States, and may or may not be registered in other countries. Other brand and product names
may be registered trademarks or trademarks of their respective holders.
in the United States, and may or may not be registered in other countries. Other brand and product names
may be registered trademarks or trademarks of their respective holders.
Part No. 801-00304-000
Published March1996
Revision 01