3com WX3000 User Manual

 

1-23 

Follow these steps to configure traffic shaping: 

Enter system view 

system-view 

— 

Enter Ethernet port view 

interface interface-type 
interface-number 

— 

Configure traffic shaping 

traffic-shape [ queue 
queue-id ] max-rate 
burst-size 

Required 

Traffic shaping is not enabled by 
default. 

Traffic shaping can be performed in 
one of the following two modes: 

z 

With the queue queue-id keyword 
and argument combination not 
specified, traffic shaping is 
performed for all the traffic. 

z 

With the queue queue-id keyword 
and argument combination 
specified, traffic shaping is 
performed for the traffic in the 
specific output queue. 

 

# Perform traffic shaping for all the traffic to be transmitted through GigabitEthernet 1/0/1, with the 

maximum traffic rate being 640 kbps and the burst size being 16 kbytes. 

<device> system-view 

[device] interface GigabitEthernet1/0/1 

[device-GigabitEthernet1/0/1] traffic-shape 640 16 

Refer to 

 for information about traffic redirecting. 

z 

The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for 

information about defining ACL rules. 

z 

The port which the packets matching the specified ACL rules are to be redirected to is determined. 

You can redirect all the packets matching specific ACL rules, or packets that match specific ACL rules 

and are of a VLAN, of a port group, or pass a port. 

Follow these steps to redirect all the packets matching specific ACL rules: 

Enter system view 

system-view 

— 

Configure traffic redirecting 

traffic-redirect inbound acl-rule interface 
interface-type interface-number 

Required