3com S330 User Manual

To set up, activate, and end a video dial-up session, follow these basic steps:

1 Create virtual circuits between the appropriate PathBuilder S330/S310 units. This 

effectively builds a call routing table.

For detailed instructions, see“Defining RS366 (Video) Virtual Circuit Templates”, 
earlier in this chapter.

2 Start the session either manually or automatically via the RS-366 interface. For 

3 End the session either manually or automatically via the V.35 interface. For details, 

see “Ending Video Dial-up Sessions” later in this section.

A video dial-up session starts (connects) automatically when someone dials a 
number matching one of the numbers in the call routing table (one of the 
numbers associated with an RS366 virtual circuit template) on a video keypad. You 
create the call routing table by building virtual circuits between PathBuilder 
S330/310 CBR modules. For details about building video virtual circuits, see 
“Defining RS366 (Video) Virtual Circuit Templates”, earlier in this chapter. For 
details about viewing the call routing table, see “Viewing the Video Call Routing 
Table” later in this section.

You can also start (connect) a video dial-up session manually. To do this, follow 
these steps:

1 From the Configuration Management menu, select [4] Manage Video Dial to 

2 From the Manage Video Dial menu, select [2] Manually Connect (Dial) A Site to 

display the Manually Connect A Site menu, shown in Figure 130. The current 
connection status is displayed at the top of the menu.

Figure 130   Manually Connect A Site Menu