3com WX1200 User Manual
11
M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
Use MAP access point commands to configure and manage MAP access
points. Be sure to do the following before using the commands:
points. Be sure to do the following before using the commands:
Define the country-specific IEEE 802.11 regulations on the WX switch.
(See set system countrycode on page 56.)
(See set system countrycode on page 56.)
Install the MAP access point and connect it to a port on the WX
switch.
switch.
Configure a MAP access port (for a directly connected MAP) or a
Distributed MAP. (See set port type ap on page 91 and set dap on
page 81.)
Distributed MAP. (See set port type ap on page 91 and set dap on
page 81.)
CAUTION: Changing the system country code after MAP configuration
disables MAP access points and deletes their configuration. If you change
the country code on a WX switch, you must reconfigure all MAP access
points.
disables MAP access points and deletes their configuration. If you change
the country code on a WX switch, you must reconfigure all MAP access
points.
MAP Access Point
Commands by
Usage
Commands by
Usage
This chapter presents MAP access point commands alphabetically. Use
Table 49 to locate commands in this chapter based on their use.
Table 49 to locate commands in this chapter based on their use.
Table 49 Map Access Point Commands by Usage
Type
Command
Automatic
Configuration of
Distributed MAPs
Configuration of
Distributed MAPs