3com WX1200 User Manual
292
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
name
MAP access point name.
boot-download-
enable
enable
State of the firmware upgrade option:
YES (automatic upgrades are enabled)
NO (automatic upgrades are disabled)
load balancing group Names of the MAP load-balancing groups to which the MAP
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of a
group.
group.
Radio
Radio number. The information listed below this field applies
specifically to the radio.
specifically to the radio.
type
Radio type:
802.11a
802.11b
802.11g
mode
Radio state:
Enabled
Disabled
channel
Channel number.
antennatype
External antenna model, if applicable.
tx pwr
Transmit power, in dBm.
profile
Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
radio to a radio profile, MSS assigns the radio to the default
radio profile.
auto-tune
max-power
max-power
Maximum power level the RF Auto-Tuning feature can set on
the radio.
the radio.
The value default means RF Auto-Tuning can set the
power up to the maximum level allowed for the country
of operation.
power up to the maximum level allowed for the country
of operation.
A specific numeric value means you or another
administrator set the maximum value.
administrator set the maximum value.
auto-tune
min-client-rate
min-client-rate
Minimum data rate the radio must maintain for associated
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.
Table 51 Output for display ap config (continued)
Field
Description