3com WX1200 User Manual

Usage — Connections are shown only for the Distributed MAPs that are 
configured on the WX switch from which you enter the command, and 
only for the Mobility Domain the switch is in.

To show information only for Distributed MAPs that have active 
connections, use the display dap connection command.

Examples — The following command displays configuration information 
for all the Distributed MAPs configured on a WX switch:

WX4400# display dap global
Total number of entries: 8
DAP Serial Id   

WX IP Address   Bias

--- ----------- 

--------------- ----

1 

M9DE48B012F00 10.3.8.111      HIGH

- 

M9DE48B012F00 10.4.3.2        LOW

2 

M9DE48B123400 10.3.8.111      LOW

- 

M9DE48B123400 10.4.3.2        HIGH

17  M9DE48B123600 10.3.8.111      HIGH
- 

M9DE48B123600 10.4.3.2        LOW

18  M9DE48B123700 10.3.8.111      LOW
- 

M9DE48B123700 10.4.3.2        HIGH

Table 61 describes the fields in this display.

Table 61   Output for display dap global

DAP

Connection ID you assigned to the Distributed MAP. 

Note: DAP numbers are listed only for Distributed MAPs 
configured on this WX switch. If the field contains a 
hyphen ( - ), the Distributed MAP configuration displayed in 
the row of output is on another WX switch. 

Serial Id

Serial ID of the Distributed MAP.

WX IP Address

System IP address of the WX switch on which the Distributed 
MAP is configured. A separate row of output is displayed for 
each WX switch on which the Distributed MAP is configured. 

Bias

Bias of the WX switch for the Distributed MAP:

„

High

„

Low