3com WX1200 User Manual
set rfdetect countermeasures mac
557
set rfdetect
countermeasures
mac
countermeasures
mac
Starts countermeasures against a specific rogue.
Syntax —
set rfdetect countermeasures mac mac-addr
mac-addr
— Basic service set identifier (BSSID) of the rogue. Enter the
BSSID in MAC address format, using a colon between each octet (for
example: aa:bb:cc:dd:ee:ff).
example: aa:bb:cc:dd:ee:ff).
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Use this command to immediately begin countermeasures
against a specific rogue in the rogue list. The MAC address you specify
must be in the list of rogues generated by RF detection scans. MSS can
issue countermeasures only against a device that is in the rogue list.
against a specific rogue in the rogue list. The MAC address you specify
must be in the list of rogues generated by RF detection scans. MSS can
issue countermeasures only against a device that is in the rogue list.
You can start countermeasures against more than one BSSID by typing
additional set rfdetect countermeasures mac commands.
additional set rfdetect countermeasures mac commands.
After you type the first set rfdetect countermeasures mac command,
MSS does not issue countermeasures against any devices except the ones
you specify using this command. To resume normal countermeasures
operation, where MSS automatically issues countermeasures against
detected rogues, use the clear rfdetect countermeasures mac all
command.
MSS does not issue countermeasures against any devices except the ones
you specify using this command. To resume normal countermeasures
operation, where MSS automatically issues countermeasures against
detected rogues, use the clear rfdetect countermeasures mac all
command.
This command is valid only on the seed switch of the Mobility Domain.
The countermeasures take effect only if countermeasures are enabled for
the Mobility Domain, using the set rfdetect countermeasures enable
command.
The countermeasures take effect only if countermeasures are enabled for
the Mobility Domain, using the set rfdetect countermeasures enable
command.
This command does not become part of the configuration file when you
save the configuration and therefore is not reloaded if the switch is
restarted.
save the configuration and therefore is not reloaded if the switch is
restarted.
Examples — The following command begins countermeasures against
rogue BSSID aa:bb:cc:11:22:33:
rogue BSSID aa:bb:cc:11:22:33:
WX1200# set rfdetect countermeasures mac aa:bb:cc:11:22:33
success: set rfdetect countermeasures mac aa:bb:cc:11:22:33
success: set rfdetect countermeasures mac aa:bb:cc:11:22:33