3com 4210 PWR 18-PORT User Manual
38
C
HAPTER
3: M
ANAGING
YOUR
S
WITCH
Figure 29 Initial Switch Setup and Management Flow Diagram
CAUTION: To protect your switch from unauthorized access, you must change all
three default passwords as soon as possible, even if you do not intend to actively
manage your switch. For more information on default users and changing default
passwords, see “Default Users and Passwords” on page 50.
three default passwords as soon as possible, even if you do not intend to actively
manage your switch. For more information on default users and changing default
passwords, see “Default Users and Passwords” on page 50.
IP Configuration
In order for the device to be remotely managed, it requires an IP address. You can
use one of the following methods to allocate IP information to your switch.
use one of the following methods to allocate IP information to your switch.
Configuring IP Manually
When you configure the IP information, the switch remembers the information
that you enter until you change it again. You should use the Manual IP
configuration method if:
that you enter until you change it again. You should use the Manual IP
configuration method if:
■
you do not have a DHCP or BootP server on your network
■
you want to remove the risk of the IP address ever changing
■
your DHCP or BootP server does not allow you to allocate static IP addresses.
(Static IP addresses are necessary to ensure that the switch is always allocated
the same IP information.)
(Static IP addresses are necessary to ensure that the switch is always allocated
the same IP information.)
For most installations, 3Com recommends that you assign a known IP address to
your switch. This makes management simpler and more reliable as it is not
your switch. This makes management simpler and more reliable as it is not
Pl
ug and
Pl
ay S
e
tup
In
it
ia
l IP
I
n
fo
rm
a
tio
n
S
e
tu
p
Feat
ure M
a
nagem
e
n
t
Power Up the Switch.
IP Information is automatically configured
using DHCP
See page 39
Do you want to manually
configure the IP information?
Connect to the con-
sole port and use the
Command Line Inter-
face.
How do you want to manage your Switch? See page 36
SNMP
Command Line Interface
Connect using the
console port.
Web Interface
Connect over the
network using Telnet.
See page 47
Connect over the
network.
How do you want to view the automatically
configured IP information?
How do you want to connect to the Switch?
Connect to a front panel port
and use the Web Interface or
Command Line
Interface.
Use 3Com Network
Director (3ND).
Connect to the console
port and use the
Command Line
Interface.
Yes
No