3com 4500 PWR 50-PORT User Manual

C

HAPTER

 11: U

SING

 AAA 

AND

 RADIUS C

OMMANDS

This section describes how to use the 802.1x configuration commands on your 
Switch 4500.

display dot1x [ sessions | statistics [ interface interface-list ]]

All views 

 Displays the 802.1x information on the specified interface.

 Displays the session connection information of 802.1x. 

 Displays the relevant statistics information of 802.1x. 

interface-list:

 Ethernet interface list including several Ethernet interfaces, 

expressed in the format 

interface-list = { interface-num [ to 

interface-num ] } & < 1-10 >

. interface-num specifies a single Ethernet 

interface in the format 

interface-num = { interface-type interface-num | 

interface-name }

, where

 specifies the interface type, 

 specifies the interface number and 

 specifies the 

interface name. For the respective meanings and value ranges, refer to 

Use the 

command to view the relevant information of 802.1x, 

including configuration information, running state (session connection 
information) and relevant statistics information. 

By default, all the relevant 802.1x information about each interface will be 
displayed. 

This command can be used to display the following information on the specified 
interface: 802.1x configuration, state or statistics. If no port is specified when 
executing this command, the system will display all 802.1x related information. 
For example, 802.1x configuration of all ports, 802.1x session connection 
information, and 802.1x data statistical information. The output information of 
this command can help the user to verify the current 802.1x configurations so as 
to troubleshoot 802.1x. 

Related commands: 

, 

, 

, 

, 

, 

, 

.

Display the configuration information of 802.1x. 

<4500>display dot1x 

Equipment 802.1X protocol is enabled

 DHCP-launch is disabled

 EAP-relay is enabled

 Proxy trap checker is disabled

 Proxy logoff checker is disabled