3com 4500 26-PORT User Manual

C

HAPTER

 1: U

SING

 S

YSTEM

 A

CCESS

 C

OMMANDS

<SW4500>system-view

System View: return to User View with Ctrl+Z.

[SW4500]user-interface 0 9

[SW4500-ui0-9]

This example command selects two AUX (Console) port user interfaces and two 
VTY user interfaces  (VTY 0, VTY 1). You can now assign access levels to these 
interfaces using the user privilege level command. 

User interface view

 Enter the level of command that a user can access, in the range 0 to 3.

Use the 

 command to configure the command level 

that a user can access from the specified user interface. The user can use all the 
available commands at this command level. Use the 

command to restore the default command level. By default, a user can access all 
commands at Level 3 after logging in through the AUX user interface, and all 
commands at Level 0 after logging in through a VTY user interface.

To configure a user to access command level 0 after logging in from the VTY 0 
user interface, enter the following:

<SW4500>system-view

System View: return to User View with Ctrl+Z.

[SW4500]user privilege level 0

When the user Telnets from the VTY 0 user interface to the switch, the terminal 
displays commands at level 0, as shown below:

<SW4500>?

User view commands:

   debugging

Debugging functions

language-mode

Specify the language environment

ping

Ping function

   quit

Exit from current command view

   super

Privilege current user a specified priority level

 

telnet

Establish one TELNET connection

   tracert

Trace route function

undo

Negate a command or set its default