3com 4500 50-PORT User Manual
Access Management Configuration Commands
117
To display the access management configurations on Ethernet1/0/1:
<4500>
display am ethernet1/0/1
Ethernet1/0/1
Status : disabled
IP Pools : (NULL)
display isolate port
Syntax
display isolate port
View
Any view
Parameter
none
Description
Use the
display isolate port
command to view port isolation information.
Example
To display port isolation information, enter the following:
<4500>display isolate port
Isolated port(s) on UNIT 1:
Ethernet1/0/1
port isolate
Syntax
port isolate
undo port isolate
View
Ethernet Port View
Parameter
none
Description
Use the
port isolate
command to add a port to an isolation group using the
following commands, and achieves port-to-port isolation between this port and
Table 11 Output Description of the
display am
Command
Field
Description
Status
AM state on the port: enabled or disabled
IP Pools
IP pools. NULL represents no configuration. Each IP address section is
represented in X.X.X.X (number), of these, "X.X.X.X" represents the
first address, and "number" represents that "number" consecutive IP
addresses from the beginning of this address are within the IP pools
represented in X.X.X.X (number), of these, "X.X.X.X" represents the
first address, and "number" represents that "number" consecutive IP
addresses from the beginning of this address are within the IP pools
Isolate Ports
Isolate ports. NULL represents no configuration