3com 4500 50-PORT User Manual
40
C
HAPTER
1: U
SING
S
YSTEM
A
CCESS
C
OMMANDS
<SW4500>system-view
System View: return to User View with Ctrl+Z.
[SW4500]user-interface 0 9
[SW4500-ui0-9]
This example command selects two AUX (Console) port user interfaces and two
VTY user interfaces (VTY 0, VTY 1). You can now assign access levels to these
interfaces using the user privilege level command.
VTY user interfaces (VTY 0, VTY 1). You can now assign access levels to these
interfaces using the user privilege level command.
user privilege level
Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level:
Enter the level of command that a user can access, in the range 0 to 3.
Description
Use the
user privilege level level
command to configure the command level
that a user can access from the specified user interface. The user can use all the
available commands at this command level. Use the
available commands at this command level. Use the
undo user privilege level
command to restore the default command level. By default, a user can access all
commands at Level 3 after logging in through the AUX user interface, and all
commands at Level 0 after logging in through a VTY user interface.
commands at Level 3 after logging in through the AUX user interface, and all
commands at Level 0 after logging in through a VTY user interface.
Example
To configure a user to access command level 0 after logging in from the VTY 0
user interface, enter the following:
user interface, enter the following:
<SW4500>system-view
System View: return to User View with Ctrl+Z.
[SW4500]user privilege level 0
When the user Telnets from the VTY 0 user interface to the switch, the terminal
displays commands at level 0, as shown below:
displays commands at level 0, as shown below:
<SW4500>?
User view commands:
debugging
Debugging functions
language-mode
Specify the language environment
ping
Ping function
quit
Exit from current command view
super
Privilege current user a specified priority level
telnet
Establish one TELNET connection
tracert
Trace route function
undo
Negate a command or set its default