Panasonic 1200N User Manual

It is recommended that configuration data be backed up any time there have been
changes made to the switch configuration that are intended to be permanent.

1.

Connect the TFTP server and the switch Ethernet port to a common Ethernet 
network. They may be directly connected to each other if an ethernet cross-
connect cable is used.

2.

Set the Ethernet IP address of the switch using the 

 command.

3.

If the two are not on the same Ether subnet, and are separated by a router, use 
the 

 command to direct the switch to the router.

4.

Backup the configuration data using the 

 command.

5.

To download a backed up configuration into the switch using the 

 command.

1.

Connect the switch and the workstation (TFTP server) with an ATM-PVC 
interface.

2.

Setup the ATM-PVC workstation (TFTP server) to use a PVC.

3.

Set the IP routing information within the switch such that the switch can upload 
the configuration data to a host within a different sub network. Use the 

 command.

4.

Backup the configuration data using the 

 command.

5.

To download a backed up configuration into the switch, use the 

 command.