Panasonic 1200N User Manual

Procedures for turning on the ATM Switch's power are shown below.

1.

Turn on the power switch on the back of the equipment by raising the switch 
up. If the power unit is redundant, turn on both power switches.

2.

Confirm that the POWER LED and the READY LED in the lower right area 
of the front of the ATM Switch are lighted green. 

The ATM Switch's self-diagnosis function is activated every time its power is
turned on and every time it is reset. The results of the self-diagnosis are output to
the MAT that is connected to the ATM Switch. 

When self-diagnosis function is executed, make sure the output message does not
contain “NG” or “Not Installed” for slot numbers corresponding to slots in which
a line card is installed. Also confirm that the ALARM LED in the lower right area
of the ATM Switch is not lighted. 

Shown below is a sample output when the ATM Switch is started.

The system is coming up now.

If you want to enter boot program, push [ESC] 

key immediately.

If the [ESC] key is detected within 3 seconds, 

boot program is loaded.

Otherwise, online program will be loaded from 

the flash memory.

ATA0=00000000--->dram=a0020000:size=00000200

ATA0=00001000--->dram=a0030000:size=00007000

ATA0=00008000--->dram=a0038000:size=00008000

:

:

Nortel Networks Corporation

ATM Service Node Model 5E

Software Version X.X(X)

Boot Program Version X.XX DD MM YY

Hardware Configuration:

CPU Board: OK;

Switch Board: OK;

PCMCIA 00: ATA OK;

PCMCIA 01: LAN OK;

Slot 00: OC-3C(MMF)OK;

Slot 01: OC-3C(MMF)OK;

Slot 02: Not Installed;

Slot 03: Not Installed;

System Initialization Complete