Panasonic ASCT1F46E User Manual
Refer to the following
page and item on
Page / Category -
Section
page and item on
Page / Category -
Section
□
Have precautions been checked in the case of switching with both high
and low loads by the same contact?
and low loads by the same contact?
p9/7-1
□
Doesn't heat dissipation occur under low temperature?
p9/7-2
□
Has transient state of contact resistance been considered?
p9/8-1
□
Are contact voltage and current 6V 1A or higher?
p9/8-2
Operating sound
□
Are there any problems regarding operating sound of relay?
p9/9-1、p9/9-2
Mechanical
noise
noise
□
Are there any problems regarding abnormal weak noise of relay?
p9/10-1、p9/10-2
□
Is temperature, humidity, atomosphere pressure within the range of use? p10/12-1
□
Have precautions been checked in the case of switching under high
humidity?
humidity?
p10/12-1
□
Is the ambient environment free from particles, dusts, sulfidizing gas,
organic gas?
organic gas?
p10/12-2
□
Is the ambient environment free from silicon?
p10/12-3
□
Is the ambient environment free from high-field magnetic instruments
such as speaker?
such as speaker?
p10/12-4
□
Are the ambient vibration and shock below the relay's vibration and
impact characteristics? Also, is there no resonance after the relay is
impact characteristics? Also, is there no resonance after the relay is
p10/12-5、p10/12-6
□
Isn't there a risk of freezing and dewing of relay?
p9/7-2、p10/12-7、p
11/12-9
11/12-9
□
Isn't there a risk of water or oil adhesion?
p11/12-8
Mounting
□
Doesn't vibration or shock cause poor connection between a relay and a
connector?
connector?
p11/13-1
□
Have precautions been checked for operating of flux applying and
automatic soldering?
automatic soldering?
p13/15-1、p15/15-2
□
Have precautions been checked for cleaning operation of print board?
p13/15-1、p15/15-2
□
Isn't glass shot performed for flux cleaning? (Particle of the glass may
get inside the relay and cause operation failure.)
get inside the relay and cause operation failure.)
p13/15-1、p15/15-2
□
Does significant warping of print board occur, which applies a force on a
relay teminal and changes the relay characteristics?
relay teminal and changes the relay characteristics?
p13/15-1、p15/15-2
□
Isn't the unused terminal cut? (Applied force on terminal can change the
characteristics.)
characteristics.)
p13/15-1、p15/15-2
Soldering
□
Any strong forces such as terminal clinch are not applied at attaching.
p18/16-3
□
Aren't load, shock, or vibration which is out of the allowable range
applied during transportation?
applied during transportation?
p18/17-1
□
Are temperature and humidity within the allowable range?
p18/17-2
□
Is the ambient atomosphere free from organic gas and sulfidizing gas?
p18/17-2
Product
handling
handling
□
Aren't dropped or fallen tube packages used?
p18/18-1
Contact
reliability
reliability
Storage,
transportation
transportation
PCB mounting
Use
environmental
condition
environmental
condition
Contact
resistance
resistance
Category
Check
box
Check item
Check sheet (2/2)