EMC DS-32B2 User Manual
1
1-424
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
supportShow
Display multiple test results for customer debugging.
The
supportShow
command is used to gather switch information for
debugging purposes. Your EMC Customer Service representative may ask
you to run this command and capture the output. This information will aid
Customer Service in diagnosing problems that could occur on the switch.
you to run this command and capture the output. This information will aid
Customer Service in diagnosing problems that could occur on the switch.
Syntax
supportShow [slot/Port1-Port2] [lines]
Availability
All users
Description
Use this command to display multiple perselected Telnet user
command results with a range of port specified in the user input
command results with a range of port specified in the user input
Operands
This command has the following operands:
slot
Specify the range of ports within the blade specified
by the slot to be displayed. Slot must be provided by
users, except for non-ED-12000B products.
by the slot to be displayed. Slot must be provided by
users, except for non-ED-12000B products.
The ED-12000B has a total of 10 slots counted from 1
to 10. Slot number 5 and 6 are control processor
cards, and slot 1 through 4 and 7 through 10 are
switch cards. On each switch card, there are 16 ports
counted from the bottom 0 to 15. A particular port
must be represented by both slot number (1 through
4 or 7 through 10) and port number (0 through 15).
to 10. Slot number 5 and 6 are control processor
cards, and slot 1 through 4 and 7 through 10 are
switch cards. On each switch card, there are 16 ports
counted from the bottom 0 to 15. A particular port
must be represented by both slot number (1 through
4 or 7 through 10) and port number (0 through 15).
port 1
Specify the first port of a range of ports to display
information. Enter the port area number. The default
(if no operand specified) is to print state of port 0. If
only
information. Enter the port area number. The default
(if no operand specified) is to print state of port 0. If
only
port1
is specified, only information for
port1
is
printed. This operand is required for v4.0.
port 2
Specify the last port of range of ports to display
information. Enter the port area number. If
information. Enter the port area number. If
port1
is
specified but
port2
is not specified, only
port2
information is printed for the port based commands
(portShow,
portRegShow, portRouteShow
). If no
operand is supplied,
port1
is set to 0 and
port2
is set
to maximum port of switch. This operand is required
for v4.0.
for v4.0.
lines
Specify the number of lines for portlogdump output.