Siemens 6ED1050-1AA00-0BE8 User Manual
Configuring LOGO!
7.1 Selecting parameter assignment mode
LOGO!
292
Manual, 04/2011, A5E03556174-01
7.1.3
Modifying parameters
You first select the parameter you want to edit (Page 291).
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change:
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change:
Press or
2. To change this value: Press or
3. To apply the value: OK
3. To apply the value: OK
7D V
7 V
%
&KDQJH3UHVV
Ⴃ
RU
Ⴍ
'RQH2.
0RYH3UHVV
Ⴑ
RU
Ⴇ
Note
When changing the time parameter when the system is in RUN, you can also change the
When changing the time parameter when the system is in RUN, you can also change the
timebase (s=seconds, m=minutes, h=hours). This does not apply if the time parameter
represents the result of another function (for an example, see the "On-delay (Page 160)"
topic). In this case you can neither change the value nor the timebase. The current time is
reset to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
7D V
7 V
%
&XUUHQWWLPH7D
&RQILJXUHGWLPH7
You can change the configured time T.
Current timer value
View of a timer cam in parameter assignment mode:
2II
2Q
' 0:)
%
You can change the on/off times and the day.