Extreme networks 12804 User Manual
Extreme Networks 325 W AC Power Supply
BlackDiamond 12800 Series Switches Hardware Installation Guide
99
Removing an Extreme Networks 325 W AC PSU
CAUTION
An operating 325 W AC PSU may be hot to the touch; use thermal protective gloves when handling the 325 W AC
PSU during removal.
PSU during removal.
CAUTION
To disconnect the system power, disconnect ALL power supply units. Disconnect the power cord before you remove
the PSU from the chassis.
the PSU from the chassis.
To remove an Extreme Networks 325 W AC PSU:
1
Attach an ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top right corner of the switch front panel.
receptacle on the top right corner of the switch front panel.
2
Disconnect the AC power cord from the wall outlet.
3
Loosen the middle screw on the power cord bracket to allow removal of the power cord. After the
screws are loosened, disconnect the AC power cord from the AC input on the front of the PSU.
screws are loosened, disconnect the AC power cord from the AC input on the front of the PSU.
4
Loosen the two captive screws that secure the PSU front panel to the chassis frame.
5
Use the handle to slide the PSU out of the chassis.
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to
handle ESD-sensitive components.
handle ESD-sensitive components.
Front Panel LEDs
The front panel of the Extreme Networks 325 W AC PSU provides status LEDs.
describes the
meanings of these LEDs.
Table 22: Extreme Networks 325 W AC PSU LEDs
PSU Condition
AC In
LED Status
LED Status
DC Out
LED Status
LED Status
No AC input power
Off
Off
No AC input power (receiving standby power from the chassis)
Amber
Off
AC input good (main outputs disabled)
Green
Off
AC input good, output fault
Green
Amber
AC input good, DC output good
Green
Green