Sun Microsystems 5802 User Manual

58

Enterprise Fabric Suite 2007 User Guide • September 2008

To view zoning properties and limits on a switch, do the following:

1. On the faceplate display, open the Zoning menu and select Edit Zoning or click 

the Zoning button to open the Edit Zoning dialog. 

2.  Choose one of the following: 

■

The zoning properties/limits are displayed under the zoning toolbar 
(

).

■

In the zone sets tree (left window pane), right-click the top zone sets entry, 
a zone, or an alias. Open the Edit menu and select Properties.

■

In the zone set tree (left window pane), select the top zone sets entry, a 
zone, or an alias. Open the Edit menu and select Properties.

3.  View the zoning limits and properties information in the Properties dialog. 

4.  Click the OK button to close the Properties dialog. 

Active Zoneset Data Window

) displays the zone membership for the 

active zone set that resides on the fabric management switch. The active zone set is 
the same on all switches in the fabric – you can confirm this by adding a fabric 
through another switch and comparing Active Zone Set displays.

To open the Active Zoneset data window, click the Active Zoneset tab below the 
data window in the topology display. Refer to 

 for more 

information about zone sets and zones.

The Active Zoneset data window (

) uses display conventions for 

expanding and contracting entries that are similar to the fabric tree. An entry handle 
located to the left of an entry in the tree indicates that the entry can be expanded. 
Click this handle or double-click the following entries:

■

A zone set entry expands to show its member zones.

■

A zone entry expands to show its member ports/devices.

■

Ports/devices that are zoned by WWN or FC address, but no longer part of the 
fabric, are grayed-out.