Sun Microsystems 5602 User Manual

A – Command Line Interface

Feature Command

59097-01 A

A-23

0

Adds license key features to the switch and displays the license key feature log. 
To order a license key contact your switch distributor or your authorized reseller. 
Upgrading a switch is not disruptive, nor does it require a switch reset.

Admin session for Add keyword only

add [license_key]
log

add [license_key]
Adds the feature that corresponds to the value given by [license_key]. 
[license_key] is case insensitive.
log
Displays a list of installed license key features.

Downloads firmware from a remote host to the switch, installs the firmware, then 
resets the switch (without a power-on self test) to activate the firmware. If 
possible, a non-disruptive activation is performed. The command prompts you for 
the following:
„

IP address of the remote host

„

An account name and password on the remote host

„

Pathname for the firmware image file

Admin

The following is an example of the Firmware Install command:

SANbox Manager (admin) #> firmware install

 Warning: Installing new firmware requires a switch reset.

 A stable farbic is required to successfully activate the firmware on a

 switch without disrupting traffic. Therefore, before continuing with

 this action, ensure there are no administrative changes in progress

 anywhere in the fabric.

 Continuing with this action will terminate all management sessions,

 including any Telnet sessions. When the firmware activation is complete,

 you may log in to the switch again.

 Do you want to continue? [y/n]: y

    Press 'q' and the ENTER key to abort this command.

  User Account    : johndoe

  IP Address      : 10.20.33.130