Sony 9000 User Manual

   

Ch
apt

er 1 

D

V

S-9

000

 F

u

n

c

tion
s

146

Setup

• Single Proc mode: The control panel controls a single switcher.
• Dual Simul mode: The control panel controls two switchers simultaneously.

• Panel Assign: Specify the switcher controlled by a control panel.
• Switcher Assign: Specify the DME connected to a switcher.

Make the following settings.

Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are as follows.

Switch the screen aspect ratio to 4:3 or 16:9.

Set the initial state of the devices when the system is powered on.
For each device, you can select Resume mode or Custom mode.

This resumes the setting state at the previous power-off operation. This setting 
is only available for the switcher processor and panel.

This uses the settings saved in non-volatile memory or ROM within the device. 
In this mode, there are Setup and Initial Status settings which can be set 
separately.
• Setup mode: Select the setup state to be used after powering on from the 

following.

User: Start up using the user data previously saved with [Setup Define].
Factory: Start up with the factory default settings.

• Initial status mode: Select the state of each device after powering on 

(excluding the settings to which “setup” applies).

User: Start up using the user data previously saved with [Initial Status 

Define]. For the control panel, this applies to the key bus delegation 
buttons only. 

Factory: Start up with the factory default settings.

SD system

59.94

480i

50

576i