Sony 9000 User Manual

155

Setup

  Cha

p

te

r 1 

D

V

S-90

00 F

unc

tions

• GPI Output: Set the GPI output ports and trigger polarities, and make the 

action settings.

In DCU setup, carry out settings particular to the DCU.
You can make the following settings.
• Input Config: Assign GPI inputs to Parallel input ports.
• GPI Input Assign: Make GPI input settings.
• Output Config: Assign GPI outputs to parallel output ports inserted in an 

option slot.

• GPI Output Assign: Make GPI output settings.
• Serial Port Assign: Set the protocol to match the devices connected to a 9-

pin serial port. You can also select the control panel used to control each 
device.

Carry out settings relating to the interface with the routing switcher, and 
settings relating to the tally interface.
You can make the following settings.

These settings are common to the parallel tally and serial tally.
• Matrix Size: Assign the switcher matrix of each switcher processor to S-Bus 

space, and select the matrix size and positioning level, source address 
settings, and so on.

• External Box: To obtain the signal selection status of external devices with 

a parallel input, assign a matrix as an external selector in the S-Bus space. 
Make the matrix size, assignment level, source address, and other settings.

• Tally Group: Select the group tally (Gp1 to 4 or Gp5 to 8) which can be 

used.

• S-Bus Tally Enable: Specify S-Bus tally enabled or disabled.