Sony 9000 User Manual
Ch
apt
apt
er 1
D
V
S-9
000
F
u
n
c
tion
s
s
70
DME Wipes
For details of creating keyframe effects, see “Creating User Programmable
DME Patterns” (page 342).
DME Patterns” (page 342).
Notes
• To use the split, page turn, and page roll effects requires the MKS-8830M
Nonlinear Effect Board to be installed in the DVS-9000 system.
• Note that for an independent key transition, only the slide, split, squeeze,
door, frame in-out, and user programmable DME patterns are available.
Signals forming part of the background for a DME wipe
In two-channel mode, or flip tumble and so on, in addition to the signals on the
A and B buses, a background signal may be visible. This background is
normally supplied by the UTIL2 bus signal.
A and B buses, a background signal may be visible. This background is
normally supplied by the UTIL2 bus signal.
DME Wipe Pattern Variation and Modifiers
You can modify the selected DME wipe pattern in the same way as an ordinary
wipe pattern, as follows.
wipe pattern, as follows.
For the setting operations, see “Setting DME Wipe Modifiers” (page 333).
Direction: You can set the DME wipe direction to normal, reverse, or
alternating normal/reverse (page 59), except for a key transition, which is
always in normal/reverse mode.
always in normal/reverse mode.
Border: You can apply a border or soft border (see page 60), except for DME
wipes in the independent key transition control block with which this
modifier cannot be used.
In the case of a user programmable DME pattern in which a border has
already been applied to the effect, the behavior is as follows.
• When the DME wipe border setting is ON, only part of the border
modifier cannot be used.
In the case of a user programmable DME pattern in which a border has
already been applied to the effect, the behavior is as follows.
• When the DME wipe border setting is ON, only part of the border
applied in the effect is enabled, and that portion can be adjusted.
• When the DME wipe border setting is OFF, the border applied in the
effect is enabled as is.
Positioner: This can only be used when one of the following pattern numbers
is selected.
1031, 1201 to 1204, 1251, 2651, 2652
With the progress of the transition, the center of the pattern automatically
moves from its initially set position toward the center of the image (see
page 61). That is to say, the same effect is obtained as in a normal wipe
when the positioner is set to “AUTO CENTER.” Again, by using the
position select function, you can move the pattern instantaneously.
1031, 1201 to 1204, 1251, 2651, 2652
With the progress of the transition, the center of the pattern automatically
moves from its initially set position toward the center of the image (see
page 61). That is to say, the same effect is obtained as in a normal wipe
when the positioner is set to “AUTO CENTER.” Again, by using the
position select function, you can move the pattern instantaneously.