Sony 9000 User Manual
Ch
apt
apt
er 1
D
V
S-9
000
F
u
n
c
tion
s
s
90
Digital Multi Effects (DME)
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] button in the device control block twice in rapid
succession. (For details, see “Three-Dimensional Transformation
Operations” in Chapter 11 (Volume 2).)
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] button in the device control block twice in rapid
succession. (For details, see “Three-Dimensional Transformation
Operations” in Chapter 11 (Volume 2).)
The following table shows the default parameter values for each
transformation operation mode.
transformation operation mode.
Resetting of parameter values set in the source coordinate space
In some transformation operation modes, if you switch to the target coordinate
space after setting up a three-dimensional transformation in the source
coordinate space, the setting values in the source coordinate space (three-
dimensional parameter values) are converted to values in the target coordinate
space (source/target conversion).
Once a conversion has taken place, the original source coordinate space
parameters do not return to their original values when you switch back to the
source coordinate space. They are reset to zeros.
Source/target conversion occurs in the following operation modes:
• Location XYZ
• Rotation
space after setting up a three-dimensional transformation in the source
coordinate space, the setting values in the source coordinate space (three-
dimensional parameter values) are converted to values in the target coordinate
space (source/target conversion).
Once a conversion has taken place, the original source coordinate space
parameters do not return to their original values when you switch back to the
source coordinate space. They are reset to zeros.
Source/target conversion occurs in the following operation modes:
• Location XYZ
• Rotation
Transformation Operation Modes
The following operation modes are available for three-dimensional DME
transformations. These operations are carried out in the device control block.
(For details, see “Three-Dimensional Transformation Operations” in Chapter
11 (Volume 2).)
transformations. These operations are carried out in the device control block.
(For details, see “Three-Dimensional Transformation Operations” in Chapter
11 (Volume 2).)
Operation mode
Default value
Location XYZ
0.00
Rotation, Spin
0.00
Axis Location
0.00
Location Size
1.00
Aspect
1.00
Perspective (x, y)
Perspective (z)
Perspective (z)
0.00
1.00
Skew
0.00