Sony MCS-8M User Manual

I-2

The model and serial numbers are located on the bottom.
Record these numbers in the spaces provided below.
Refer to these numbers whenever you call upon your Sony 
dealer regarding this product.

Model No.                               Serial No.                                

This symbol is intended to alert the user to 
the presence of important operating and 
maintenance (servicing) instructions in the 
literature accompanying the appliance.

When installing the installation space must be secured in 
consideration of the ventilation and service operation.
• Do not block the ventilation slots at the left side and right 

side panels, and vents of the fans.

• Leave a space around the unit for ventilation.
• Leave more than 40 cm (15 

3

/

4

 in.) of space in the rear of 

the unit to secure the operation area.

When the unit is installed on the desk or the like, leave at 
least 10 cm (4 in.) of space in the left and right sides. 
Leaving 40 cm (15 

3

/

4

 in.) or more of space above the unit 

is recommended for service operation.

WARNING: THIS WARNING IS APPLICABLE FOR 
USA ONLY.
If used in USA, use the UL LISTED power cord specified 
below.
DO NOT USE ANY OTHER POWER CORD.

Plug Cap

Parallel blade with ground pin
(NEMA 5-15P Configuration)

Cord

Type SJT, three 16 or 18 AWG wires

Length

Minimum 1.5 m (4 ft. 11 in.), 
Less than 2.5 m (8 ft. 3 in.)

Rating

Minimum 10 A, 125 V

Using this unit at a voltage other than 120 V may require 
the use of a different line cord or attachment plug, or both. 
To reduce the risk of fire or electric shock, refer servicing 
to qualified service personnel.

WARNING: THIS WARNING IS APPLICABLE FOR 
OTHER COUNTRIES.
1. Use the approved Power Cord (3-core mains lead) / 

Appliance Connector / Plug with earthing-contacts that 
conforms to the safety regulations of each country if 
applicable.

2. Use the Power Cord (3-core mains lead) / Appliance 

Connector / Plug conforming to the proper ratings 
(Voltage, Ampere).

If you have questions on the use of the above Power Cord 
/ Appliance Connector / Plug, please consult a qualified 
service personnel.

For the customers in the U.S.A.
This equipment has been tested and found to comply with 
the limits for a Class A digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference when 
the equipment is operated in a commercial environment. 
This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in 
accordance with the instruction manual, may cause 
harmful interference to radio communications. Operation 
of this equipment in a residential area is likely to cause 
harmful interference in which case the user will be 
required to correct the interference at his own expense.

You are cautioned that any changes or modifications not 
expressly approved in this manual could void your 
authority to operate this equipment.

All interface cables used to connect peripherals must be 
shielded in order to comply with the limits for a digital 
device pursuant to Subpart B of Part 15 of FCC Rules.

This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) 
this device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.

For the customers in Canada
This Class A digital apparatus complies with Canadian 
ICES-003.