Sony 4-296-436-11 (2) User Manual

Page of 63
II-41
Making the Necessary Settings
  
C
h
ap
te
r 6
  
3D
 Sy
s
te
m
Making the Necessary 
Settings
Make the settings for operating the unit in a 3D system in 
the [Setup] menu.
Display the [Setup] menu by pressing the SETUP button in 
the menu control block.
Setting the Signal Format and Video 
Size
1
Display the [Setup] menu, select [System] menu > 
[System Format], and use the corresponding knobs to 
make each of the following settings.
The [Aspect] of the video is fixed at 16:9.
For details on the setting, see “Configuring the Signal Format and 
Aspect Ratio” (
c Basic Operation).
2
Press the V3 or V4 knob.
A message prompting you to restart the unit appears.
3
Press the V3 knob (OK).
Turning 3D Mode On
1
Display the [Setup] menu, select [System] menu > [3D 
Mode], turn the V4 knob to select [On].
2
Press the V4 knob.
A message prompting you to restart the unit appears.
3
Press the V3 knob (OK), and then turn off the unit and 
turn it on again.
• In 3D mode, the BKGD bus delegation button will be lit, 
and the KEY, AUX 1, and AUX 2 buttons will be 
disabled.
• Next transition is fixed at BKGD.
• Transition types will be fixed at MIX.
• The FTB and KEY TRANS buttons in the transition 
control block will be disabled.
• The numeric keypad block will be disabled.
• In the menu control block, only the MISC, FILE, and 
SETUP buttons will be enabled.
In addition, menus will be restricted as follows.
[Misc] menu
[Setup] menu
Knob
Parameter Meaning
Setting Value
V3
Format
Signal 
format
108059 (1080i/
59.94), 108050 
(1080i/50), 720p59 
(720p/59.94), 
720p50 (720p/50)
V4
Aspect
Aspect 
ratio of 
video
16:9
Tip
Knob
Parameter Meaning
Setting 
Value
V4
3D
Turns 3D mode on/off Off, On
Tips
Menu item
Restriction
Transition 
Rate (1/2)
• Only the [Effect] transition rate is enabled.
Transition 
Rate (2/2)
• Setting is disabled.
Color 
BKGD
• Setting is disabled.
Port Enable • [GPI] is fixed at [Disbl] (disable).
• Only [RS232C] can be selected.
Menu item
Restriction
Video 
(XPT)
• Movement to the sub-level setting is 
disabled (assignments for cross-point 
buttons are fixed).
Video 
(Output)
• Movement to the sub-level setting is 
disabled (assignments for video output 
are fixed).
Multi 
Viewer
• Only setting of the number of sub-screens 
is enabled.
• Assignment of video to the sub-screens is 
fixed.
GPI/Tally
• Movement to the sub-level setting is 
disabled.