Freescale Semiconductor M9328MX21ADSE User Manual
Configuration and Operation
M9328MX21ADSE User’s Manual, Rev. A
2-16
Freescale Semiconductor
2.5.2
Using the Keypad
To use the keypad module, connect the 20 conductor ribbon cable supplied with the ADS from connector
P1 of the Keypad module to P5 of the M9328MX21ADSE Base board.
P1 of the Keypad module to P5 of the M9328MX21ADSE Base board.
2.5.3
Using a NAND Flash Card
CAUTION
To avoid circuit damage, do not plug-in the NAND Flash card with power
applied to the board.
applied to the board.
To use the NAND Flash module supplied with the ADS, connect PN1 & PN2 of the NAND Flash module
to PM1 & PM2 on the CPU board. Before installing the card, make sure that S1-4 (the NEXUS_ON
switch) is OFF and that the PCMCIA Daughter Card is not installed. For details on the NAND Flash
interface, refer to the specification document on the documentation CD.
to PM1 & PM2 on the CPU board. Before installing the card, make sure that S1-4 (the NEXUS_ON
switch) is OFF and that the PCMCIA Daughter Card is not installed. For details on the NAND Flash
interface, refer to the specification document on the documentation CD.
2.5.4
Using a SD/MMC Card
Connector P6 on the Base board is a SD/MMC card holder. You must obtain a compatible card for use with
this connector. Note the card power is connected to 3.0 V
this connector. Note the card power is connected to 3.0 V
2.5.5
Using Image Sensor Daughter Card
Connector PE1 is pre-configured to operate directly with the IM8012 image sensor daughter card supplied
with the ADS. Communication with this card takes place through the I
with the ADS. Communication with this card takes place through the I
2
C interface. For details on image
sensor operation, refer to the data sheet on the documentation CD
CAUTION
To avoid circuit damage, do not plug-in the image sensor card with power
applied to the board.
applied to the board.
To install the image sensor card, plug its 48 position DIN connector into PE1 of the Base board. When the
image sensor card is installed, the two boards are at a right angle to each other, with the image sensor facing
away from the Base board.
image sensor card is installed, the two boards are at a right angle to each other, with the image sensor facing
away from the Base board.
2.5.6
Using the PCMCIA Daughter Card
CAUTION
Make sure that the input power to the Base board is disconnected when
installing the PCMCIA daughter card.
installing the PCMCIA daughter card.
To use the PCMCIA daughter card supplied with the ADS, install the card in the sockets PK1 and PK2 on
the CPU board. Before installing the daughter card, make sure that S1-4 (the NEXUS_ON switch) is OFF
and that there is no NAND Flash card installed at PM1 & PM2.
the CPU board. Before installing the daughter card, make sure that S1-4 (the NEXUS_ON switch) is OFF
and that there is no NAND Flash card installed at PM1 & PM2.
You must supply a compatible PCMCIA card for use with the PCMCIA daughter card.