Avaya M770 User Manual
Chapter 10
Managing PNNI Routing
142
Avaya M770 ATM Switch User’s Guide
PNNI Configuration Commands
In Hierarchical PNNI, there is a need to configure the nodes separately on different
levels. Therefore, there is an additional parameter to indicate the level that is
currently being configured. You may omit this parameter for the configuration
show commands. In this case, the command would refer to all levels.
levels. Therefore, there is an additional parameter to indicate the level that is
currently being configured. You may omit this parameter for the configuration
show commands. In this case, the command would refer to all levels.
Showing all PNNI configured variables
To show important 1
st
level PNNI variables use the following command:
Note:
Configuration of the first level requires a switch reset. Therefore, the output of
the 'Show' command gives both current values (in brackets) and configured value
(as currently stored in the NVRAM).
(as currently stored in the NVRAM).
To show PNNI variables for all levels use the same command with no level
parameter:
parameter:
Command:
M15-155s8:/>route pnni config show [<level>]
Output:
Level 1 -
=========
Level Scope: Configure [Current]: 56 [ 56 ]
Admin Status: Up Oper Status: Up Restricted Transit:
No
Node id: Configure [Current]
38.A0.39.04.01.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.2
3.00
[
38.A0.39.04.01.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.2
3.00 ]
Atm Addr:
39.04.01.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.23.81
PG id: Configure [Current]
38.39.03.00.00.00.00.00.00.00.00.00.00.00
[ 38.39.03.00.00.00.00.00.00.00.00.00.00.00 ]
Command:
M15-155s8:/>route pnni config show