Denon AVP-A1HD User Manual

A2

A4

Set remote control ID.
Match the ID setting of the remote control unit and the receiver.

• When  changing  the  remote  ID,  also  change  the  AMP,  iPod  and

NET/DTU modes of the main remote control unit at the same time
(

vmpage 70

,

mpage 72

).

• When changing the remote ID, also change the sub remote control

unit  at  the  same  time  (

vmpage  75

,

mpage  77

).

A1

A3

Set usage of OPT4 OUT.

The  ZONE4  operations  cannot  be  performed  when  set  to  “Rec
Select”.

A3

A5

Set  when  external  controller  or  2-way  remote  control  unit  (RC-
7000CI and RC-7001RCI, sold separately) is connected.

In order to use a 2-way remote control (RC-7000CI or RC-7001RCI, sold
separately),  set “2Way  Remote”.  In  this  case,  the  RS-232C  terminal
cannot be used for an external controller.

A4

A6

Adjust display brightness of the receiver.

Press the

button.

Bright

Dim

Dark

OFF

A5

A7

Protect settings from inadvertent change.

• When “Setup  Lock”  is  set  to “ON”,  the  settings  listed  below  can

no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.

⋅  GUI menu operations

⋅  RESTORER

⋅  Parameters

⋅  MultEQ® XT 32

⋅  Channel Level

⋅  Audio Delay

• To cancel the setting, press the

button to re-display the “Setup

Lock” screen, then change the setting to “OFF”.

A6

A8

This  sets  the  function  for  maintenance  by  a  DENON  service
person or installer. (For professional use only.)

Only use this function if so instructed by a DENON service person or
installer.

This function allows a DENON service person or installer to check the
unit’s status and make settings via the Internet.

:  Set when using an external controller.

:  Set when using a 2-way remote control unit.