LevelOne FBR-1404TX User Manual

LevelOne Broadband VPN Gateway User Guide 

Use the LAN link on the main menu to reach the LAN screen. An example screen is shown 
below. 

 

IP address for the LevelOne Broadband VPN Gateway, as seen from 
the local LAN. Use the default value unless the address is already in 
use or your LAN is using a different IP address range. In the latter 
case, enter an unused IP Address from within the range used by your 
LAN. 

The default value 255.255.255.0 is standard for small (class "C") 
networks. For other networks, use the Subnet Mask for the LAN 
segment to which the LevelOne Broadband VPN Gateway is attached 
(the same value as the PCs on that LAN segment). 

• 

If Enabled, the LevelOne Broadband VPN Gateway will allocate 
IP Addresses to PCs (DHCP clients) on your LAN when they start 
up. The default (and recommended) value is Enabled. 

• 

If you are already using a DHCP Server, this setting must be 
Disabled, and the existing DHCP server must be re-configured to 
treat the LevelOne Broadband VPN Gateway as the default Gate-
way. See the following section for further details. 

• 

The Start IP Address and Finish IP Address fields set the values 
used by the DHCP server when allocating IP Addresses to DHCP 
clients. This range also determines the number of DHCP clients 
supported. 

See the following section for further details on using DHCP. 

Save the data on screen. 

The "Cancel" button will discard any data you have entered and reload 
the file from the LevelOne Broadband VPN Gateway. 

14