Brocade Communications Systems 53-1001761-01 User Manual

Managing and displaying the FCoE login configuration

13

Perform the following task to configure FIP multicast advertisement intervals.

Clearing logins

Perform the following task to clear logins.

Displaying FCoE configuration-related information

Perform the following tasks to display FCoE-related configuration information.

Managing and displaying the FCoE login configuration

Another important task in administrating FCoE is configuring the FCoE login information.

Enabling or disabling FCoE login 
configuration management

The fcoelogincfg command allows only configured Enode VN_ports to log in. Use the fcoelogingroup 
command to configure allowed Enode VN_ports. The default is disabled.

Disabling the fcoelogincfg command allows unrestricted login on Enode VN_ports.

Task

Command

Configure FIP multicast advertisement intervals. 
Syntax is as follows:

•

intvl—Specifies the interval in seconds. The 
minimum interval value is 0 seconds and 
the maximum value is 300 seconds. A value 
of 0 cancels the previous advertisement 
interval value. 

switch:admin> fcoe --fipcfg -advintvl intvl

Task

Command

Clear the logins that occurred through a front-end 
port or from a device specified by the Enode's 
VN_port WWN. Syntax is as follows:

•

-teport slot/port—Specifies the slot or port 
number.

•

-device wwn—Specifies the device WWN.

switch:admin> fcoe --resetlogin -teport slot/port | 
-device wwn

Task

Command

Display the embedded FCoE port configuration. 
Configurations of all the ports are displayed if you 
do not specify a specific port. 

switch:admin> fcoe --cfgshow [port]

Display information about devices logged into a 
specific FCoE F_port.

switch:admin> fcoe --loginshow [port]

Display FIP configurations.

switch:admin> fcoe --fipcfgshow