Belkin F1DN102D Leaflet

This section supplements the Belkin Quick Installation Guide in accordance with AGD_PRE.1 Common Criteria 
Assurance Measure requirements.

This User Guidance and Common Criteria EAL 4 validation apply to the TOE Common Criteria Evaluated version of 
OmniView

®

 Secure KVM Models listed below:

 
•   F1DN102D   
•   F1DN104D  

Before you begin: The users of the Belkin OmniView

®

 Secure DVI Dual-Link KVM Switch must review all associated 

documentation and guidance prior to proceeding with installation and use of the KVM Switch. All documentation and 
guidance can be found in the following document(s):

•   Belkin OmniView

®

 Secure DVI Dual-Link KVM Switch User Manual F1DN102D, F1DN104D   

 

(document number PM00507) 

•  Belkin OmniView

®

 Secure DVI Dual-Link KVM Quick Installation Guide F1DN102D, F1DN104D   

 

(document number PM00506)

Receipt
•  Assure that tamper seals are intact on the KVM switch. There should be one tamper-evident tape on each side 

of the Switch enclosure (total of two tapes). If both tapes are visible and do not appear to be disrupted, the 
Switch has not been opened or compromised since time of production. If for any reason one of the tapes is 
missing or appears disrupted, the user should call Belkin Technical Support at (800) 282-2355.

Environment preparation
•  The Belkin OmniView KVM secure must be located in a physically secure location providing physical protection 

and limited (authorized user) access controls.

The following are authorized devices for the Common Criteria Evaluated configuration. Assure that installation 
processes resulting in the following hardware/firmware configuration:

TOE 

 Belkin Secure DVI Dual-Link KVM Switch 2-Port  PN # F1DN102D v.111111    (or)                     

 

Belkin Secure DVI Dual-Link KVM Switch 4-Port  PN # F1DN104D v.111111

 

including: Firmware software component version 1.0.1

Environment 

USB Mouse (Peripheral Group Member)

Environment 

USB Keyboard (Peripheral Group Member)

Environment 

Monitor – Dual-Link DVI connector (Peripheral Group Member)

Environment 

Host Computers Qty. 2 or 4 based on KVM used (IT Environment Computer Resources) 

Environment   

Belkin DVI/USB KVM Cable (one per KVM):

 

F1D9201-06 – 6 ft. (1.8m)

 

F1D9201-10 – 10 ft. (3m)

 

F1D9201-15 – 15 ft. (4.6m)