Billion Electric Company BiPAC 3100SN User Manual
4
2.2 Device Overview
The Description of each labeled part is described in the table below.
WLAN LED
Lit green when the wireless function is enabled.
Blinking when data is transmitted or received
via WLAN
.
Blinking quickly when WPS is proceeded.
Power LED
Lit
green
when the device is power on.
Lit off when po
wer is off.
ETH (Ethernet
Link/Act) LED
Lit
green
when connected to an Ethernet device.
Blinking when data is transmitted or received via Ethernet port.
WPS Button
Push this button to trigger Wi-Fi Protected Setup function.
Reset Button
Press this button for more than 2 seconds until WLAN LED blinking and then
release this button to reset device to factory default settings.
Ethernet Port
Connect the Ethernet Access Point device with an Ethernet device
(e.g. computer, router, hub/switch, IP pone, IPTV set-top-box, gaming
consoles…), using the RJ-45 Ethernet cable included.
Power Plug / AC
Power Cord
Plug into an AC outlet for power supply.
Clip Socket
Install the clip into this socket.
Note: Please DO NOT remove or disassemble the socket clip frequently
Note: Please DO NOT remove or disassemble the socket clip frequently
as this may cause serious damage on your Ethernet Access Point
device.
Ethernet Port
Power Plug
Reset Button
WLAN LED
Power LED
ETH LED
WPS Button
Clip Socket